Re: OSPF on 32 bit dialer interface

Tauseef,

I just finished the lab, It works fine, just remove the no peer neighbor-route and without and OSPF network type configuration.

--
Mohammad Mousa
CCIE #36990
On Nov 28, 2012, at 5:20 PM, Mohammad Mousa wrote:
> Tauseef,
> 
> Try to remove the no peer neighbor-route command, you configured the
> virtual-template interface as /24 and you give the dialer side /32 host route.
> When you remove the no peer neighbor command, you will install /32 host route
> on each side. also as Joe said you don't have to configure ospf networks
> type.
> 
> 
> Try this and let me know what will happen.
> 
> 
> --
> Mohammad Mousa
> CCIE 336990
> 
> 
> 
> 
> 
> 
> 
> On Nov 28, 2012, at 2:24 PM, Tauseef Khan wrote:
> 
>> sorry made a mistake in pasting
>> ip local-pool 6.6 172.31.255.254
>> 
>> !
>> peer default ip address 6.6
>> 
>> Regrads
>> 
>> On 28 November 2012 11:22, Mohammad Mousa <mohd-mousa_at_hotmail.com> wrote:
>> Before I lab it up, I noticed your pool name is different than of you've
> called it.
>> 
>>> nterface Virtual-Template16
>> 
>>> peer default ip address pool 1.6
>> 
>> 
>>> ip local-pool 6.6 172.31.255.254
>> 
>> Did you receive ip address on the Dialer side?
>> 
>> --
>> Mohammad Mousa
>> CCIE #36990
>> 
>> 
>> 
>> On Nov 28, 2012, at 2:03 PM, Tauseef Khan wrote:
>> 
>>> Please find below the configs
>>> server:R1
>>> 
>>> bba-group pppoe CISCO
>>> virtual-template 16
>>> !
>>> interface Gigabit0/0
>>> no ip address
>>> ip ospf network point-to-multipoint
>>> ip ospf mtu-ignore
>>> duplex auto
>>> speed auto
>>> pppoe enable group CISCO
>>> end
>>> 
>>> !
>>> interface Virtual-Template16
>>> mtu 1492
>>> ip address 172.31.255.1 255.255.255.0
>>> ip ospf network point-to-multipoint
>>> ip ospf mtu-ignore
>>> peer default ip address pool 1.6
>>> ppp authentication chap
>>> end
>>> 
>>> usename R2 password pass
>>> 
>>> ip local-pool 6.6 172.31.255.254
>>> 
>>> __________________________________________________
>>> 
>>> Client R2:
>>> interface FastEthernet0/0
>>> no ip address
>>> ip ospf network point-to-multipoint
>>> ip ospf mtu-ignore
>>> speed auto
>>> half-duplex
>>> pppoe enable
>>> pppoe-client dial-pool-number 16
>>> !
>>> 
>>> interface Dialer16
>>> mtu 1492
>>> ip address negotiated
>>> encapsulation ppp
>>> ip ospf network point-to-multipoint
>>> dialer pool 16
>>> dialer idle-timeout 0
>>> dialer persistent
>>> no peer neighbor-route
>>> ppp chap password 0 pass
>>> end
>>> 
>>> R2:
>>> sh ip ospf int br
>>> Interface    PID   Area            IP Address/Mask    Cost  State Nbrs F/C
>>> __________________________________________________________________________
>>> Di16         1     2               172.31.255.254/32      1785  P2MP  0/0
>>> __________________________________________________________________________
>>> 
>>> Kind regards
>>> 
>>> Tauseef
>>> mobile: +44 7837209187
>>> 
>>> 
>>> On 28 November 2012 10:10, Mohammad Mousa <mohd-mousa_at_hotmail.com> wrote:
>>> Post your full configs so we can check together. Did you change the MTU?
>>> 
>>> --
>>> Mohammad Mousa
>>> CCIE #36990
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> On Nov 28, 2012, at 12:28 PM, Tauseef Khan wrote:
>>> 
>>>> Appreciate if some one could help. I have  ospf running on 2 routers R1
> and
>>>> R2.
>>>> R2 is a PPPoE client and R1 is the server.  R2 has a negotiated ip
> address
>>>> on the dialer interface from R1 which is host (/32) address while R1 has
> a
>>>> /29 bit Ip address on its interface facing towards Client.
>>>> OSPF adj is not coming up between the client and Server
>>>> On client dialer int and Server int I have ip ospf network
>>>> point-to-multipoint
>>>> i also tried no peer neighbor-route on client dialer interface.
>>>> 
>>>> debugs on the client side show:
>>>> OSPF: Rcv pkt from 172.31.29.1, Dialer16, area 0.0.0.3 : src not on the
>>>> same network
>>>> 
>>>> I have tried changing the network type to poin-to-poitn as well but no
> adj
>>>> 
>>>> Regards
>>>> 
>>>> 
>>>> Blogs and organic groups at http://www.ccie.net
>>>> 
>>>> _______________________________________________________________________
>>>> Subscription information may be found at:
>>>> http://www.groupstudy.com/list/CCIELab.html
> 
> 
> Blogs and organic groups at http://www.ccie.net
> 
> _______________________________________________________________________
> Subscription information may be found at: 
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net