Re: CCIE Lab Exam Opening Moves

From: ccie99999 <ccie99999_at_gmail.com>
Date: Fri, 19 Oct 2012 12:13:53 +0000

Stupid question: wouldn't be easier to store the initial on the flash with
a special name and in case also archive the conf before every macro
configuration step?
Is this something advisable for the Lab? I talking about r&S.
Thanks

@ccie99999
Il giorno 19/ott/2012 13:53, "Anthony Sequeira" <terry.francona_at_gmail.com>
ha scritto:

> Starting with the IPS initialization as a potential launch point. I LOVE
> it.
> Thank you so very much Sadiq for taking the time for this feedback.
>
> From: Sadiq Yakasai <sadiqtanko_at_gmail.com>
> Date: Friday, October 19, 2012 7:07 AM
> To: Anthony Sequeira <terry.francona_at_gmail.com>
> Cc: "ccielab_at_groupstudy.com certification" <ccielab_at_groupstudy.com>
> Subject: Re: CCIE Lab Exam Opening Moves
>
> Very good - I like it! I had an attack plan as well when I went to bed with
> the beast.
>
> One thing worthy of including somewhere in there is saving the initial
> configuration of all devices in the flash memory. Many times, in trying to
> configure additional items that the exam requires, candidates end up
> modifying the initial config and the only way to confirm what was initially
> there is via a saved configuration. Some people would do this by copying
> the
> running-config into note pad and saving (or just leaving it open on the
> desktop). Greatly helps I tell you!
>
> Also, as a strategy, I always did start with the IPS device (although not
> critical). The IPS device can sometimes break a network into multiple
> segments before its configured. Therefore, for me, to start building my
> network, I always like to initialize it first (not necessarily complete the
> whole IPS section). But this is just my preference.
>
> HTH a bit.
>
> Sadiq
>
> On Fri, Oct 19, 2012 at 11:49 AM, Anthony Sequeira
> <terry.francona_at_gmail.com> wrote:
> > CCIE Security Challenge - 1 Week Out - Opening Moves
> >
> >
> >
> > I think it was my dear friend Bruce Caslow of NetMasterClass.com who
> first
> > used the words opening moves when it comes to the CCIE Lab Exam.
> >
> >
> >
> > I have been speaking with many CCIE Security Instructors about the CCIE
> > Security Exam and the smartest opening moves for this beast. It is pretty
> > interesting because my approach and opening moves to this exam will vary
> > dramatically from what I did in my Routing and Switching exam.
> >
> >
> >
> > In this post I am going to accomplish a couple of things:
> >
> >
> >
> > 1 - Write out my opening moves so I am completely clear on them for my
> > upcoming CCIE Lab Exam attempt.
> >
> >
> >
> > 2 - Publish these in an as many spots as I can to gather any feedback
> about
> > them, or collect some opening moves ideas that my peers and I had not
> > thought of.
> >
> >
> >
> > 3 - share these moves with anyone that might be preparing for this CCIE
> > Security Version 3 lab exam.
> >
> >
> >
> > 4 - share these strategies and the overall strategic approach for
> candidates
> > of other CCIE tracks to get them thinking about such planning.
> >
> >
> >
> > So what are the opening moves I am planning to make in the CCIE Security
> 3.0
> > Lab Exam? Here they are:
> >
> >
> >
> > Step 1 - Confirm the proper setup of my lab materials. Since this exam is
> > paper-based - I will examine my lab notebook and make sure all pages
> appear
> > to be there, and that they have not given me a Voice lab :-| I will
> then
> > use any logical topology diagram in the lab notebook to ensure that my
> > initial configurations have loaded properly. I will check one router and
> one
> > ASA; or two routers if it appears I have to configure both ASAs from
> > scratch. I will notify the proctor IMMEDIATELY should there be any issues
> > with my initials. Time: 2 minutes
> >
> >
> >
> > Step 2 - I will then read the entire exam paper closely. I will try and
> spot
> > interdependencies and pitfalls in how the security tasks relate to each
> > other. ASA filtering, Zone-Based Firewall filtering, the IPS policy, and
> NAT
> > are all areas worth noting considering that configurations here can
> easily
> > cause lab exam failure. I will also examine the diagrams provided
> closely to
> > ensure that they are going to work for me in the exam. I will determine
> at
> > this point if I will be re-diagramming any areas. Time: 10 minutes
> >
> >
> >
> > Step 3 - I will then begin any re-diagramming I might need to do and
> start
> > my first configuration. I presume I will be starting with an ASA, but I
> have
> > certainly made no assumptions where I will begin as my lab will
> ultimately
> > dictate that. Before beginning the configuration of any device - I will
> copy
> > the initial configuration of that device into Notepad on the desktop.
> When I
> > copy this configuration, I will visually parse it and look for any
> setting
> > that Cisco may have introduced in the interest of forcing me to
> > troubleshoot. Areas to look for include ACLs, VACLs, shutdown ports,
> > incorrect or duplicate IPs, incorrect physical port settings, and default
> > command reversals.
> >
> >
> >
> > Step 4 - start my Skipped Task Tracker and track any tasks that I am
> > skipping, either due to level of difficulty, or the fact that the task
> would
> > be best completed at a later time in the lab construction.
> >
> >
> >
> > Well, those are the opening moves my friends. I so look forward to
> feedback.
> > I think just like in a game of chess, these opening moves can really set
> the
> > tone for eventual success or failure. I do not plan on taking them
> lightly
> > and winging it!9
> >
> >
> >
> > Anthony Sequeira, CCIE, CCSI, VCP
> >
> > http://www.stormwind.com
> >
> > Twitter: @compsolv
> >
> > Facebook: http://www.facebook.com/compsolv
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> >
> >
> >
> >
> >
>
>
>
> --
> CCIEx2 (R&S|Sec) #19963
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Oct 19 2012 - 12:13:53 ART

This archive was generated by hypermail 2.2.0 : Thu Nov 01 2012 - 10:53:33 ART