Re: [OT]Creating a unidirectional link failure scenario

What do you mean by simulate ? Cause you have already done that
by removing one fibre!

In a 10/100 ethernet you can cut one wire. No such luck on giga.
In dynamips, you can block one stream or point to some unused port.

-Carlos

sundeep sadhwani @ 05/04/2012 06:49 -0300 dixit:
> Hi all
>
> I would need your suggestions in creating an unidirectional link failure
> scenario.
>
> i have two devices connected back to back GSR-----4500 through fibre. I
> have removed the Rx of the fibre from the GSR end. At the GSR end if i
> disable the negotiation the link interface on GSR comes up however if i
> disable the negotiation on 4500 port, the interface is still down.
>
> Any suggestion of simulating this would be appreciated.
>
> Regards
> Sundeep
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>

-- 
Carlos G Mendioroz  <tron_at_huapi.ba.ar>  LW7 EQI  Argentina
Blogs and organic groups at http://www.ccie.net