Re: Nexus Vrf

You can configure the Nexus with management inband without using the mgmt0 interface , however I believe to better to use the management interface for the management and source my ntp, syslog, Tacacs , snmp out of the management VRF.

I'm on an iPhone, but later I can reply with greater detail.

Regards,
 Joe Sanchez

On Mar 30, 2012, at 8:26 AM, OLUSEGUN DADA <engrenny_at_hotmail.com> wrote:

> Hello all,
>
> When configuring Vrf using IOS, inter Vrf traffic can be configure on a single
> device using static for example. But on NX-OS (nexus 5548), I find it hard to
> allow traffic from the management Vrf going to the Default Vrf using static
> routes. Is this possible? When the static route is configured, it will not be
> seen in the management Vrf routing table, i believe this is due to the
> Prerequisites of static routing in NX-OS
>
> All my interface connecting to the network are in Default Vrf. Only the Mgmt
> interface is in the Management Vrf. I want the management interface to be
> reachable in the network and be used for sourcing Traffic like Ntp, Syslog,
> Snmp e.t.c. but it is connecting to a peer Nexus 5548 switch for Peer
> keep-alive traffic for vPC, I don't have a different management network. All
> devices are managed In-Band.
>
>
> Regards
> Dada Olusegun (CCIE 32395)
> +234-80-8440-7185
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Mar 30 2012 - 08:45:44 ART