Question: Auto QOS - 4507R

I am in the middle of a CCM install and I'm not really a voice guy so there
is a learning curve. However, I cannot seem to get auto QoS configured on
my 4507. Just so I understand it..

I have Auto QoS installed on my 3560's.
- Port Level = I configured "auto qos voip cisco-phone"
- Uplink = I configured "auto qos voip trusted"

However, when I try to enable QoS on my Link to the 3560's from my 4507, I
get the following:
*- MAG4507(config-if)#auto qos voip trust*
*- AutoQoS Error: the following generated command was not properly applied*
*- qos*
*- AutoQoS Error while generating commands on Gi7/15*

Here is a show module... I'm thinking the code may be the problem.
However...
*MAG4507#sh qos
QoS is enabled globally
IP header DSCP rewrite is enabled
*

MAG4507#sh mod
Chassis Type : WS-C4507R
Power consumed by backplane : 40 Watts
Mod Ports Card Type Model Serial
No.
---+-----+--------------------------------------+------------------+-----------
 1 2 Supervisor II+ 1000BaseX (GBIC) WS-X4013+
JAE1047FK5Q
 2 2 Supervisor II+ 1000BaseX (GBIC) WS-X4013+
JAE0918B54U
 3 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45
JAB084502KE
 4 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45
JAB062105VF
 5 24 10/100/1000BaseT (RJ45) WS-X4424-GB-RJ45
JAE1029757F
 6 48 10/100/1000BaseT (RJ45) WS-X4448-GB-RJ45
JAB06190BAU
 7 18 1000BaseX (GBIC) WS-X4418
JAE043301QC
 M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
 1 000c.306a.0dc0 to 000c.306a.0dc1 4.3 12.2(31r)SGA 12.2(25)EWA13 Ok
 2 000c.306a.0dc2 to 000c.306a.0dc3 3.3 12.2(20r)EW1 12.2(25)EWA13, Ok
 3 0012.7f99.ff10 to 0012.7f99.ff3f 1.1 Ok
 4 0007.0eca.99a0 to 0007.0eca.99cf 1.0 Ok
 5 0016.c73d.b0d0 to 0016.c73d.b0e7 1.8 Ok
 6 0005.5fa4.dd90 to 0005.5fa4.ddbf 1.1 Ok
 7 0002.b92e.0fd2 to 0002.b92e.0fe3 1.5 Ok
Mod Redundancy role Redundancy mode Redundancy status
----+-------------------+-------------------+-------------------
 1 Active Supervisor SSO Active
 2 Standby Supervisor SSO Standby hot
Is this bootflash accurate for qos? *
bootflash:cat4000-i9k91s-mz.122-25.EWA13.bin*
Thanks for any insight.

Greg

Blogs and organic groups at http://www.ccie.net
Received on Fri Oct 28 2011 - 09:20:04 ART