I want to do dot1q trunking over LTPTv3 however Its not working and I under
pressure to get this working for the customre by tomorrow, so urgent advise
will be appreciated.
my topology is below with the L2TPv3 tunnel endpoint facing the switch on
both ends.
switch --------------------ISR2921----------------------------L2TP
TUNNEL------------------------------------ISR2921---------------------------SWITCH
The L2TPv3 tunnel is up on the ISR2921, but the trunking is not working from
switch to switch. I can only ping via vlan1 from one switch to the other,
which is the native vlan. However if i try to ping from a tagged dot1q vlan
from a pc connected to the switch on both ends in the same vlan, it doesnt
ping . Please can someone advise my config is below. Is there anything else
i need to do to allow Dot1q over L2TPv3 tunnel?
ISR2921 Router CONFIG (mirror config on other end)
pseudowire-class qassim
encapsulation l2tpv3
protocol l2tpv3 qassim
ip local interface Loopback0
ip pmtu
ip tos reflect
ip tos value 184
!
!
!
!
!
interface Loopback0
ip address 2.2.2.2 255.255.255.255
!
interface GigabitEthernet0/0
description L3 WAN LINK
bandwidth 10000
ip address 192.168.1.1 255.255.255.252
load-interval 30
duplex auto
speed 10
service-policy output queue-on-out
!
!
!
interface GigabitEthernet0/0/0
description INTERFACE TO SWITCH - L2TPv3 endpoint
no ip address
negotiation auto
no keepalive
xconnect 1.1.1.1 1 pw-class qassim
!
!
SWITCH CONFIG (mirror config on other end)
vlan 100
interface GigabitEthernet0/0
description INTERFACE TO ISR2921
switchport trunk
interface GigabitEthernet 0/1
description INTERFACE TO LAPTOP (PC)
switchport access vlan 100
interface vlan 1
ip address 10.1.1.1 255.255.255.0
Thanks in Adance
Blogs and organic groups at http://www.ccie.net
Received on Tue Aug 23 2011 - 18:37:56 ART
This archive was generated by hypermail 2.2.0 : Thu Sep 01 2011 - 06:05:56 ART