Re: Qos for different customers on corporate switch

Another common practice would be to police inbound on your basement
switch (2960) and to shape outbound on your L3 PE end.
Based on your diagram it would be shaping on outbound on your ISR router
sub-interface.

HTH
A.

On 8/22/2011 9:16 PM, Carlos G Mendioroz wrote:
> What's wrong with just rate limiting the customer port ?
> I.e. police with a specific policy applied to incoming
> and outgoing traffic through its interface...
>
> -Carlos
>
> Irfan Sid @ 21/08/2011 10:39 -0300 dixit:
>> can someone please advise
>>
>> much appreciated
>>
>> On Sat, Aug 20, 2011 at 2:44 PM, Irfan Sid <lifeoverip_at_gmail.com> wrote:
>>
>>> Dear Group..
>>>
>>> If a Corporation is sharing out its infrastructure to other third
>>> parties
>>> and wants to limit bandwidth it gives to each third party customer
>>> then what
>>> is the best way to design and configure this.
>>>
>>> Do I configure each customer access port with a unique Cos value and
>>> then
>>> match it on ISR and then put them into different queues and police them
>>> based on the cos value
>>> Is there any better design and more efficient way of doing this on the
>>> setup below
>>>
>>> The corporate topology is below and multiple third parties will
>>> share the
>>> corporate infrusture from Site A to Site B.
>>>
>>> SITE
>>> A
>>> SITE B
>>> Catalyst2960 ---- ISR2921-------------- WAN MPLS CLOUD
>>> -------------------------ISR2920--------------------Catalyst2960
>>>
>>> Please advise on design and configuration...
>>> Kind Regards
>>>
>>> Irfan S.
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Aug 22 2011 - 23:12:55 ART