Cisco Voice gateway E1 testing

I am planning to deploy a simple Cisco Voice Gateway solution using Cisco
2921 ISRs configured with 2-Port T1/E1 Multiflex Trunk Voice interfaces. I
have configured the devices to interwork with our Nortel CS1000 using E1
QSIG.

The topology is as below

SITE
A
         SITE B

PBX E1----------ISR2921------------------------MPLS
WAN------------------------------------ISR2921--------------------E1 PBX

I have set up the devices in the lab and would like to prove the
configuration. Is there any way to test the configuration in the lab without
terminating the E1 on a PBX and simulate a call between the sites.

Thanks in advance

Blogs and organic groups at http://www.ccie.net
Received on Sun Aug 21 2011 - 16:38:29 ART