Re: PortChannel down - down

You may want to consider shutting the interfaces down before creating the
portchannel.

On Fri, Jan 28, 2011 at 11:48 AM, Bryan Stair <uptown.ccie_at_gmail.com> wrote:

> I don't believe that it is. I had the same behavior running my c3550's. At
> first it was very discouraging since it 's a basic setup with commands.
> Restart your devices to see if the problems persist. If that does not work
> I
> would wipe everything out and start again. I think it may have ahd
> something
> to do with the order in which I created the channels. O
>
> Otherwise after the reboot things were working fine.
>
> On Thu, Jan 27, 2011 at 7:32 AM, Raghava Rao <raghava.rao85_at_gmail.com
> >wrote:
>
> > Etherchannel down
> >
> > I am running on dynamips.......SW2&SW4 portchannel down..
> >
> > portchannel is configured..
> >
> > but when i try to put trunk ports i am getting following errors
> > *Either port* is *L2 and port*-*channel* is *L3*, or vice-versa.
> >
> > and if do no switchport on these and then add to channel grp its nt
> allwng
> > any command
> >
> >
> > is this dynamips behaviour?
> >
> > pls let me know...
> >
> >
> >
> > --
> > Cheers!
> > Raghav
> >
> > "It's choice - not chance - that determines your destiny"
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Jan 28 2011 - 13:00:10 ART