Re: ipv6 vrf for 7609

Mustafa,

The VRF configuration for ipv6 is a little different... Try this...

10Gig_Test(config)#mls ipv6 vrf
10Gig_Test(config)#vrf definition TEST
10Gig_Test(config-vrf)#address-family ipv6
10Gig_Test(config-vrf-af)#?
IP VPN Routing/Forwarding instance configuration commands:
  default Set a command to its defaults
  exit-address-family Exit from vrf address-family configuration submode
  export VRF export
  import VRF import
  inter-as-hybrid Inter AS hybrid mode
  maximum Set a limit
  no Negate a command or set its defaults
  protection Configure local repair
  route-target Specify Target VPN Extended Communities
  snmp Modify snmp parameters

then use the vrf forwarding TEST under the interface...

On Tue, Jan 18, 2011 at 2:02 PM, Mustafa Yadav <mustafa.yadav_at_gmail.com> wrote:
> hi,
>
> when I try to enable address family ipv6 under vrf in 7609 it gives below
> error.Does anyone know it does not support or I misconfigured something?
>
> I enabled ipv6 unicast routing and ipv6 cef.
>
> then I create vrf definition.
>
> I am trying to use vrf for ipv6 address.
>
> thnaks
>
> VRF address family ipv6 i
>
> xxx(config-vrf)#address-family ipv6
> % VRF address family ipv6 is not supported or not enabled
> % Can't activate address-family 'ipv6'
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jan 18 2011 - 14:22:42 ART