Re: VTP Clients

in the book ccie routing and switching 4th edition it says that if the
switch is in transparent mode then the extended vlans are save in running
config ...

but i think if you make copy run start then it should be saved in startup
config but are the extended vlans were not saved in vlan.dat file ???/

On Wed, Dec 1, 2010 at 5:44 PM, Maarten Vervoorn <mr.vervoorn_at_gmail.com>wrote:

> It store the vlan's in the vlan.dat
> For example if you configure a client switch and this client received a
> couple of VLANs from a VTP server it stores those in the vlan.dat. Even if
> you configure the same client switch as transparent afterwards it remains it
> vlans because it has stored them in the vlan.dat
>
> Kind regards,
>
> Maarten vervoorn
>
> 2010/12/1 Faisal Ilyas <faisal.learning_at_gmail.com>
>
>> Salam,
>>
>> I have a query that if i have a switch in transparent/server mode it will
>> store the vlan information into vlan.dat file but if i make that same
>> switch
>> into VTP Client mode and it took the update from another vtp server/client
>> switch depends on CR number but let suppose it gets the updates, so where
>> that switch will save the vlan configuration, in running config or it will
>> replace its own vlan.dat once it will get the updates ...
>>
>>
>>
>>
>> --
>> Regards,
>> M. Faisal.
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>>
>>
>>
>>
>>
>

-- 
Regards,
M. Faisal.
Blogs and organic groups at http://www.ccie.net