Re: not able to ping..kindly help

Can you post exact configs and problem faced . I am unable to figure
out your prob .

1) Make sure that there is one and only one switching module in your
router ( else stack might be required )
2) In switching module ; I think only mode "trunk" and "access" is
supported . Nothing else .

Please dont compare this switching module with standard cat switch

Thnx
Gaurav Madan
CCIE

On Sun, Nov 28, 2010 at 10:20 AM, Raghava Rao <raghava.rao85_at_gmail.com> wrote:
> Gurus
>
> i am unable to ping ...from R1 to R4
>
> set up is R1 ------SW1 --------3 trunk ports ---------SW4 -------R4
>
> R1 & R4 is in vlan 130, access ports are in vlan 130 & allowed on trunk...
>
> When i am looking at sh int f1/13 trunk...i can see that trunk negotiation
> is disabled
> im using dynamips 3725 router with switching module...
>
> kindly help
>
> --
> Cheers!
> Raghava
>
> "It's choice - not chance - that determines your destiny"
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Nov 28 2010 - 14:06:08 ART