Re: not able to ping..kindly help

I think this is just a VM problem. I get this sometimes too. What I'll advise - delete vlan 130 from the switches and then add it again. It could fix it.

You might also want to disable all the trunk links bar one till you know what's going on.

Cheers.

Emmanuel

....from my iPhone!

On 28 Nov 2010, at 08:36, GAURAV MADAN <gauravmadan1177_at_gmail.com> wrote:

> Can you post exact configs and problem faced . I am unable to figure
> out your prob .
>
> 1) Make sure that there is one and only one switching module in your
> router ( else stack might be required )
> 2) In switching module ; I think only mode "trunk" and "access" is
> supported . Nothing else .
>
> Please dont compare this switching module with standard cat switch
>
> Thnx
> Gaurav Madan
> CCIE
>
> On Sun, Nov 28, 2010 at 10:20 AM, Raghava Rao <raghava.rao85_at_gmail.com> wrote:
>> Gurus
>>
>> i am unable to ping ...from R1 to R4
>>
>> set up is R1 ------SW1 --------3 trunk ports ---------SW4 -------R4
>>
>> R1 & R4 is in vlan 130, access ports are in vlan 130 & allowed on trunk...
>>
>> When i am looking at sh int f1/13 trunk...i can see that trunk negotiation
>> is disabled
>> im using dynamips 3725 router with switching module...
>>
>> kindly help
>>
>> --
>> Cheers!
>> Raghava
>>
>> "It's choice - not chance - that determines your destiny"
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Nov 28 2010 - 11:02:04 ART