RE: Cisco 881 QoS for the switchports

What exactly are you trying to do. It appears you want to rate-limit
everything received on a particular port. Why not just remark everything
dscp 1, then use a scavenger class on the fa4 interface. I'd put the port in
a different vlan and then you could rate-limit based on destination address.
Eddie Kempe did a presentation at Networkers on using a gre tunnel on the
router itself between two vrf's and using a QoS policy on the tunnel itself.

David

--
http://dcp.dcptech.com
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> Edouard Zorrilla
> Sent: Tuesday, November 16, 2010 6:04 PM
> To: David Prall; ccielab_at_groupstudy.com
> Subject: Re: Cisco 881 QoS for the switchports
> 
> Thanks David for getting back to me.
> 
> Do any one know some tricks to do QoS for the switchports ?.,
> 
> Thanks.
> 
> -----Original Message-----
> From: David Prall
> Sent: Tuesday, November 16, 2010 2:53 PM
> To: 'Edouard Zorrilla' ; ccielab_at_groupstudy.com
> Subject: RE: Cisco 881
> 
> Fast0 - 3 are all switchports. Fast4 is a routed interface where you
> can do
> real QoS configuration. There are a number of tricks that can be done
> to do
> QoS for the switchports, just not on them.
> 
> David
> 
> --
> http://dcp.dcptech.com
> 
> 
> > -----Original Message-----
> > From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf
> Of
> > Edouard Zorrilla
> > Sent: Tuesday, November 16, 2010 5:43 PM
> > To: ccielab_at_groupstudy.com
> > Subject: Cisco 881
> >
> > Hello Guys,
> >
> > I have a Cisco 881 and I want to set up a bservice-policy input
> > limit-httpb and bservice-policy output limit-httpb on F2 so that I
> > can
> > limit the bandwidth on both ways.
> >
> >
> > Test118.108(config-if)#service-policy input http-limit
> > Weighted Fair Queueing feature not supported in input policy.
> > Bandwidth command not allowed at parent level in input direction
> > Test118.108(config-if)#
> >
> > Do you know if there is a way to do that so that I can limit inbound
> > and
> > outbound bandwidth ?.
> >
> > Thanks.
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> 
> 
> Blogs and organic groups at http://www.ccie.net
> 
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
> 
> 
> Blogs and organic groups at http://www.ccie.net
> 
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net