Re: Dial-peer question

Ryan,

Here is the output from sh run | s voice service voip:

rtr218-CP#sh run | s voice service voip
voice service voip
 sip
  bind control source-interface GigabitEthernet0/0.4
  bind media source-interface GigabitEthernet0/0.4
  rel1xx disable

g0/0.4 is the default gateway for the voice vlan.

As far as dtmf, I didn't have anything configured, but I just ran through
all four options and they all rang busy.

If I dial and existing ephone-dn the call goes right through to voice mail
and if I set the E&M circuit to plar with the AA number all calls make it to
the AA. I think I need to step away from this one for an hour or so.
Probably been looking at it too long.

Any ideas are very welcome.

-Bobby

On Wed, Oct 27, 2010 at 11:29 AM, Ryan West <rwest_at_zyedge.com> wrote:

> Bobby,
>
>
>
> Have you verified the AA functionality? Your config is on the money, I
> tested with a lab system and can dial in through a PRI link just fine. I
> tried most explicit and then worked my way out to . on both the dial-peer
> and translation-rules and each time it was fine.
>
>
>
> I tested your translation-rules as well, no issue there either. What are
> you doing for DMTF relay (not that I think its related to this issue).
> Also, if youre able to dial into the CUE/AA from an IP phone, can you post
> the output from show run | s voice service voip
>
>
>
> -ryan
>
>
>
> *From:* Robert Kimble [mailto:hoodooman21_at_gmail.com]
> *Sent:* Wednesday, October 27, 2010 12:03 PM
> *To:* Ryan West
> *Cc:* Cisco certification
> *Subject:* Re: Dial-peer question
>
>
>
> Thanks Ryan,
>
>
>
> I'm not sure where I'm going wrong though....
>
>
>
> Here's the info:
>
>
>
> Pilot number: 2101
>
> non-existing extension: 2004
>
> CUE address: 10.218.4.100
>
> Circuit: E&M wink with 4 digits being passed off
>
>
>
> Configs:
>
>
>
> voice translation-rule 1
>
> rule 1 /..../ /2101/
>
> !
>
> !
>
> voice translation-profile to_AA
>
> translate called 1
>
>
>
> dial-peer voice 2 voip
>
> translation-profile outgoing to_AA
>
> destination-pattern ....
>
> session target ipv4:10.218.4.100
>
> codec g711ulaw
>
> no vad

Blogs and organic groups at http://www.ccie.net
Received on Wed Oct 27 2010 - 11:49:43 ART