RE: Dial-peer question

Bobby,

Have you verified the AA functionality? Your config is on the money, I tested
with a lab system and can dial in through a PRI link just fine. I tried most
explicit and then worked my way out to .... on both the dial-peer and
translation-rule's and each time it was fine.

I tested your translation-rule's as well, no issue there either. What are you
doing for DMTF relay (not that I think it's related to this issue). Also, if
you're able to dial into the CUE/AA from an IP phone, can you post the output
from 'show run | s voice service voip'

-ryan

From: Robert Kimble [mailto:hoodooman21_at_gmail.com]
Sent: Wednesday, October 27, 2010 12:03 PM
To: Ryan West
Cc: Cisco certification
Subject: Re: Dial-peer question

Thanks Ryan,

I'm not sure where I'm going wrong though....

Here's the info:

Pilot number: 2101
non-existing extension: 2004
CUE address: 10.218.4.100
Circuit: E&M wink with 4 digits being passed off

Configs:

voice translation-rule 1
 rule 1 /..../ /2101/
!
!
voice translation-profile to_AA
 translate called 1

dial-peer voice 2 voip
 translation-profile outgoing to_AA
 destination-pattern ....
 session target ipv4:10.218.4.100
 codec g711ulaw
 no vad

Blogs and organic groups at http://www.ccie.net
Received on Wed Oct 27 2010 - 16:29:07 ART