Re: QoS netflow analyzer

OK, Thanks for your advice Rob.

2010/10/18 Rob Routt Jr. (rrouttjr) <rrouttjr_at_cisco.com>

> It could be your analyzer is reporting erroneous information based on
> your netflow configuration. If you have CAR configured correctly, most
> likely this is the issue. Many times you will hear of people using
> netflow and the collector reporting more than 100% utilization on
> interfaces. This is typically because the active timeout is not set. IF
> you are using any encrypted tunneling protocols on this interface, it
> can cause the traffic to be counted twice as well. I am not trying to
> plug a product here, but plixer.com has a pretty good support forum
> (systrax.com) that might be able to help you on netflow specific issues
> and why you might be seeing this behavior.
>
> Hth,
>
> Rob
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> roberto gonzalez
> Sent: Monday, October 18, 2010 10:48 AM
> To: ccielab_at_groupstudy.com
> Subject: QoS netflow analyzer
>
> Hi,
>
> I configured CAR on serial interface with 1024 mb of bandwith and i get
> netflow statistics with netflow analyzer software.
>
> CAR is configured to limit for 1024 mb exceed is configured to drops
> packets
> and is working but on netflow analyzer i see peaks until 2 mb. Anybody
> knows
> why???
>
>
> Thanks in advance
>
> Regards
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Oct 19 2010 - 09:57:37 ART