Re: Inverse-ARP with no LMI

Yes, InARP does not work properly if LMI is disabled.

Mohamed Ouamer
http://www.ciscocciebootcamp.com

2010/10/17 Muzammil Malick <malickmuz_at_gmail.com>

> Hi all
>
> When I have the following config I have no problems with connectivity
> and I can see inverse-arp requests and replies:
>
>
> interface Serial1/0
> ip address 10.0.0.1 255.255.255.0
> encapsulation frame-relay IETF
> serial restart-delay 0
> frame-relay interface-dlci 102
> end
>
> However when I switch off LMI on the interface (below) I can only see
> inverse-arp requests but no replies and so ping fails. Is inverse-arp
> dependent on LMI?
>
> interface Serial1/0
> ip address 10.0.0.1 255.255.255.0
> encapsulation frame-relay IETF
> no keepalive
> serial restart-delay 0
> frame-relay interface-dlci 102
> end
>
> Thanks
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Oct 17 2010 - 14:36:17 ART