RE: intervlan routing issue

This command is not supported on 2960 POE switch .

From: jpoplawski_at_starkinvestments.com
To: i_sameer_at_hotmail.com; mmunem_at_gmail.com; ccielab_at_groupstudy.com
Date: Tue, 12 Oct 2010 15:28:47 -0500
Subject: RE: intervlan routing issue

Looks like your missing encapsulation on the port as well
                Switchport trunk enc dot1

Give that a whirl and see.
JB

From: sameer inam [mailto:i_sameer_at_hotmail.com]
Sent: Tuesday, October 12, 2010 3:24 PM
To: Poplawski, James; mmunem_at_gmail.com; ccielab_at_groupstudy.com
Subject: RE: intervlan routing issue

after yours advice now the I enabled the ip nat nat on port 0/1.100 and switch
port config below

interface FastEthernet0/24
 description UPLINK TO CISCO ROUTER
 switchport trunk native vlan 3
 switchport trunk allowed vlan 3,100
 switchport mode trunk
 switchport nonegotiate
 load-interval 30

> From: jpoplawski_at_starkinvestments.com
> To: mmunem_at_gmail.com; i_sameer_at_hotmail.com; ccielab_at_groupstudy.com
> Date: Tue, 12 Oct 2010 15:12:48 -0500
> Subject: RE: intervlan routing issue
>
> He concealed the 1918 Addresses, so it's okay. As for that Public IP, those
aren't unique or anything... :)
>
> Is the router able to ping hosts on both subnets?
>
> Ip routing is enabled?
> Conf t
> Ip routing
>
> Perhaps NAT is the culprit as well (ip nat inside on fa0/1.100)
> Conf t
> Int fa 0/1.100
> Ip nat inside
>
> Not that it's necessary but this command can get removed on fa 0/24 on the
switch
> Int fa 0/24
> No switchport voice vlan 100
>
> Beyond that, those are my best guesses without labbing it up and sending you
a bill! :)
>
> HTH,
> JB
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
mmunem_at_gmail.com
> Sent: Tuesday, October 12, 2010 3:08 PM
> To: sameer inam; ccielab_at_groupstudy.com
> Subject: Re: intervlan routing issue
>
> Sameer, this is not company confidential stuff you've put out on a mailing
list is it?!
> Sent using BlackBerry. from Orange
>
> -----Original Message-----
> From: sameer inam <i_sameer_at_hotmail.com>
> Sender: nobody_at_groupstudy.com
> Date: Tue, 12 Oct 2010 19:47:38
> To: <ccielab_at_groupstudy.com>
> Reply-To: sameer inam <i_sameer_at_hotmail.com>
> Subject: intervlan routing issue
>
> Hello Experts ,
>
>
> I m having some issue with intervlan routing , I have cisco 1841 router
> connected with cisco 2960 poe switch , some reason I m not able to access
from
> Network A to network B please see below the configuration of router , One
> thing I would like mention here I m using LLDP Run on Cisco switch for
Avaya
> Ip phones . and on router running OSPF for DMVPN only 10.0.95.x Subnet
> advertize across the DMVPN ospf . please advice .
>
>
>
> interface FastEthernet0/0
> description UPLINK WITH SAUDI LL
> ip address 77.221.97.122 255.255.255.248
> ip nat outside
> ip virtual-reassembly
> ip route-cache flow
> load-interval 30
> duplex auto
> speed auto
> !
> interface FastEthernet0/1
> no ip address
> no ip redirects
> load-interval 30
> duplex auto
> speed auto
> !
> interface FastEthernet0/1.3
> encapsulation dot1Q 3 native
> ip address 10.0.95.x 255.255.255.0
> no ip redirects
> ip nat inside
> ip virtual-reassembly
> !
> interface FastEthernet0/1.100
> encapsulation dot1Q 100
> ip address 10.0.96.x 255.255.255.0
> no ip redirects
> !
>
> Switch Port config connected with Router
>
> interface FastEthernet0/24
> description UPLINK TO CISCO ROUTER
> switchport trunk native vlan 3
> switchport trunk allowed vlan 3,100
> switchport mode trunk
> switchport nonegotiate
> switchport voice vlan 100
> load-interval 30
> spanning-tree portfast
> end
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>
> This transmission contains information for the exclusive use of the intended
recipient and may be privileged, confidential and/or otherwise protected from
disclosure. Any unauthorized review or distribution is strictly prohibited.
Our company is required to retain electronic mail messages, which may be
produced at the request of regulators or in connection with litigation.
Electronic messages cannot be guaranteed to be secure, timely or error-free.
As such, we recommend that you do not send confidential information to us via
electronic mail. This communication is for informational purposes only and is
not an offer or solicitation to buy or sell any investment product. Any
information regarding specific investment products is subject to change
without notice. If you received this transmission in error, please notify the
sender immediately by return e-mail and delete this message and any
attachments from your system.

This transmission contains information for the exclusive use of the intended
recipient and may be privileged, confidential and/or otherwise protected from
disclosure. Any unauthorized review or distribution is strictly prohibited.
Our company is required to retain electronic mail messages, which may be
produced at the request of regulators or in connection with litigation.
Electronic messages cannot be guaranteed to be secure, timely or error-free.
As such, we recommend that you do not send confidential information to us via
electronic mail. This communication is for informational purposes only and is
not an offer or solicitation to buy or sell any investment product. Any
information regarding specific investment products is subject to change
without notice. If you received this transmission in error, please notify the
sender immediately by return e-mail and delete this message and any
attachments from your system.

Blogs and organic groups at http://www.ccie.net
Received on Tue Oct 12 2010 - 20:30:39 ART