RE: IPV6 ROUTER EIGRP AS#

What is your image version? I see it on my router.

R1(config-if)#ipv6 router eig 1
R1(config-rtr)#de
R1(config-rtr)#default?
default default-information default-metric

R1(config-rtr)#default-
R1(config-rtr)#default-?
default-information default-metric

R1(config-rtr)#default-me
R1(config-rtr)#default-metric ?
  <1-4294967295> Bandwidth in Kbits per second

R1(config-rtr)#default-metric

Thanks,
Sonu

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Elliott Reyes
Sent: Tuesday, August 17, 2010 9:14 AM
To: garry baker
Cc: Cisco certification
Subject: Re: IPV6 ROUTER EIGRP AS#

Funny I didn't see it either on my same software and hardware..

INE ?

On Mon, Aug 16, 2010 at 12:35 PM, garry baker <baker.garry_at_gmail.com>
wrote:

> command reference says it exists:
>
>
>
http://www.cisco.com/en/US/docs/ios/ipv6/command/reference/ipv6_04.html#
wp2372182
>
> but not in my router with Cisco IOS Software, 3700 Software
> (C3725-ADVENTERPRISEK9-M), Version 12.4(15)T12, RELEASE SOFTWARE (fc3)
>
> Router(config)#ipv6 router eigrp 1
> Router(config-rtr)#?
> default Set a command to its defaults
> distance Administrative distance
> distribute-list Filter networks in routing updates
> exit Exit from IPv6 routing protocol configuration
mode
> log-neighbor-changes Enable/Disable EIGRP neighbor logging
> log-neighbor-warnings Enable/Disable EIGRP neighbor warnings
> maximum-paths Forward packets over multiple paths
> metric Modify EIGRP routing metrics and parameters
> neighbor Specify a neighbor router
> no Negate a command or set its defaults
> passive-interface Suppress routing updates on an interface
> redistribute Redistribute IPv6 prefixes from another
routing
> protocol
> router-id router-id for this EIGRP process
> shutdown Shutdown protocol
> stub Set EIGRP as stubbed router
> timers Adjust routing timers
> variance Control load balancing variance
>
> --
> Garry L. Baker
>
> "There is no 'patch' for stupidity." - www.sqlsecurity.com
>
>
> On Mon, Aug 16, 2010 at 10:07 PM, Elliott Reyes <
> fontananetworkengineer_at_gmail.com> wrote:
>
>> Under ipv6 router eigrp (AS)
>>
>> I was doing the INE Lab 12 section 3.5 task and peaked at the
solution
>> guide
>>
>> It say's to add the
>>
>> default-metric command in there. I don't see it on my code level and
under
>> the command guide it say's that's only for IPV6 OSPF
>>
>> Is that right ?
>>
>> Thanks,
>>
>> Elliott
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>>
Received on Tue Aug 17 2010 - 11:01:43 ART