Re: IPV6 ROUTER EIGRP AS#

command reference says it exists:

http://www.cisco.com/en/US/docs/ios/ipv6/command/reference/ipv6_04.html#wp2372182

but not in my router with Cisco IOS Software, 3700 Software
(C3725-ADVENTERPRISEK9-M), Version 12.4(15)T12, RELEASE SOFTWARE (fc3)

Router(config)#ipv6 router eigrp 1
Router(config-rtr)#?
  default Set a command to its defaults
  distance Administrative distance
  distribute-list Filter networks in routing updates
  exit Exit from IPv6 routing protocol configuration mode
  log-neighbor-changes Enable/Disable EIGRP neighbor logging
  log-neighbor-warnings Enable/Disable EIGRP neighbor warnings
  maximum-paths Forward packets over multiple paths
  metric Modify EIGRP routing metrics and parameters
  neighbor Specify a neighbor router
  no Negate a command or set its defaults
  passive-interface Suppress routing updates on an interface
  redistribute Redistribute IPv6 prefixes from another routing
protocol
  router-id router-id for this EIGRP process
  shutdown Shutdown protocol
  stub Set EIGRP as stubbed router
  timers Adjust routing timers
  variance Control load balancing variance

--
Garry L. Baker
"There is no 'patch' for stupidity." - www.sqlsecurity.com
On Mon, Aug 16, 2010 at 10:07 PM, Elliott Reyes <
fontananetworkengineer_at_gmail.com> wrote:
> Under ipv6 router eigrp (AS)
>
> I was doing the INE Lab 12 section 3.5 task and peaked at the solution
> guide
>
> It say's to add the
>
> default-metric command in there. I don't see it on my code level and under
> the command guide it say's that's only for IPV6 OSPF
>
> Is that right ?
>
> Thanks,
>
> Elliott
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net