Re: Default Hardware Queue

did you check on serial card .. i mean WIC / HWIC ?

Gaurav Madan
CCIE

On Tue, Jun 8, 2010 at 6:58 PM, Nathan Richie <nathanr_at_boice.net> wrote:
> I am reading the QOS book by Wendell Odom and it states that the default
> hardware queue length for serial controllers is 16. It goes on to state that
> when you configure any kind of queueing on the interface that it changes the
> default to 2. However, when I look at the controllers on my 2811, it shows
> the tx-ring set to 2, even without any software queueing configured. I am
> sure that the information in the book was correct as of the time it was
> published, but does anybody know if it was changed in a certain version of
> IOS. Or if there are different defaults for different interfaces?
>
> Regards,
>
> Nathan Richie
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jun 08 2010 - 19:56:22 ART