Re: ASA - Inside outside NAT

If you want nat-control must be enable ,

then use
1)static (inside,outside) 0.0.0.0 0.0.0.0
2)access-list out_access_in permit icmp any any echo-reply (apply it on
outside interface direction IN)

Thanks
Shahid Ansari
Kuwait

On Mon, Apr 19, 2010 at 12:04 AM, jockey wearer <jockeywearer_at_gmail.com>wrote:

> Hi all,
>
> I have configured cisco ASA firewall which is connected with inside and
> outside networks.Inside and outside networks has 3 networks internally . i
> am using rip protocol for reachability .
> On my firewall nat-control is enabled and I need to allow inside network
> to
> access outside network and outside to inside network .
> I want to put minimal configuration on firewall .
> Infact I have bet with my friend to success ICMP from both side of network
> (inside and outside) by using only two command statement on firewall
> (without disabling nat-control)
> is it possible and which way is good one .I am little bit confused.I think
> it is not possible in two commands ???
>
> Thanks
> Prashant
> CISSP
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Apr 19 2010 - 00:21:50 ART