RE: OT- Wireless LAP to AP 1131AG-E-K9

There are several ways of doing it. Here is a Cisco link. The easiest
is if you have a controller then you can type one line in to the
controller and it will pull the new IOS from a TFTP server and then boot
into autonomous mode.

http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/u
pgrade/guide/lwapnote.html#wp157689

I believe the 1131's with still work using the reset button too. Have a
TFTP server with an Autonomous IOS named as the default for that model
setup on 10.0.0.3. Hold the reset button while applying power. Keep
holding the button until The light turns red and then release.

Hope that helps

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Stephen Robinson
Sent: Wednesday, April 07, 2010 10:13 AM
To: jockey wearer; group-study
Subject: Re: OT- Wireless LAP to AP 1131AG-E-K9

Here is how I did it (but you need a second AP that has the code you
need)

On a working AP
ap1#archive tar /create c1130-k9w7-mx.123-7.JA1.tar
/c1130-k9w7-mx.123-7.JA1

This tar9s everything in the folder /c1130-k9w7-mx.123-7.JA1 to tar
file
called c1130-k9w7-mx.123-7.JA1.tar
(200+ files in 20+ folders)

(On the AP9s everything except the config file is in a folder)

So on the non working one I used the aironet ROMmon equivalent (called
ap:
mode) to wipe the flash and copy the ios. Then I booted into the ios
(tons
of errors because non of the software for the radio was on the flash)
then
I copied over the tar from the first step and then ran

Archive tar /xtract <tar file from step 1> /<folder to put it in>

Actual commands were....

ap2#mkdir c1130-k9w7-mx.123-7.JA1
ap2#archive tar /xtract c1130-k9w7-mx.123-7.JA1.tar
/c1130-k9w7-mx.123-7.JA1

This created all folders and files.
I then deleted the original IOS that I used for recovery and rebooted.

The first time I did this it took an hour... The second one took 5
minutes...

Email direct at the address below if I can help further

-- 
Stephen L. Robinson
srobinson_at_qtzl.com 
> From: jockey wearer <jockeywearer_at_gmail.com>
> Reply-To: jockey wearer <jockeywearer_at_gmail.com>
> Date: Wed, 7 Apr 2010 17:41:02 +0300
> To: group-study <ccielab_at_groupstudy.com>
> Subject: OT- Wireless LAP to AP 1131AG-E-K9
> 
> Dear champs ,
> 
> I want to convert Cisco LAP to AP .I have cisco AIR-LAP 1131AG-E-K9
wireless
> lightweight accesspoint .
> any procedure how to convert LAP  to AP ? I  know procedure from AP to
LAP .
> 
> Thanks
> Prashant
> 
> 
> Blogs and organic groups at http://www.ccie.net
> 
>