Re: RIP V1 VLSM

Yes.

Sarad if i could mention, this is something you could quickly & easily lab
up in dynamips ;)
As the loopbacks are part of the same classful network as the outgoing int (
10.0.0.0/8),
you will see 10.2.0.0 coming into R2, and 10.3.0.0 coming into R1.
If the loopbacks were not part of the classful boundary as the outgoing
interface they would be summarised to their classful network boundary.
This is all assuming you are running RIPv1 with auto summary enabled.

Regards
Roy

On 16 February 2010 16:59, Sarad <tosara_at_gmail.com> wrote:

> Hi Nadeem,
>
> Then will I be able to see 10.2.0.0 on R2 & 10.3.0.0 on R1?
>
> Sara
>
>
> On Tue, Feb 16, 2010 at 10:22 PM, Nadeem Rafi <nrafia_at_gmail.com> wrote:
>
> > you will not be able to see /24 as rip v1 will be sending /16 major
> network
> > only.
> >
> > HTH
> >
> > On Tue, Feb 16, 2010 at 7:39 PM, Sarad <tosara_at_gmail.com> wrote:
> >
> >> Hi Expert,
> >>
> >> If I have the following scenario, that is two routers connected back to
> >> back
> >> with a 10 range /16 ip & there are two loopbacks configured on each
> router
> >> with the same class IPs. If I run RIPV1 on this. Will it advertise my
> >> loopbacks to each other.
> >>
> >> R1
> >> R2
> >> S0 - 10.1.0.1/16 <---------------------------> S0 -10.1.0.2/16
> >> L0 <http://10.1.0.2/16L0> - 10.2.0.1/24
> >> L0 - 10.3.0.1/24
> >>
> >> Regards
> >> Sara
> >>
> >>
> >> Blogs and organic groups at http://www.ccie.net
> >>
> >> _______________________________________________________________________
> >> Subscription information may be found at:
> >> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Regards
Roy
Blogs and organic groups at http://www.ccie.net