Gaurav,
Boot to ROMMON and use 'unset BAUD'.
Step 5 here:
Documentation for the command here:
Mark
#17755, Security
On Tue, Jan 12, 2010 at 11:12 AM, Routt, Rob <Rob.Routt_at_itron.com> wrote:
> Gaurav,
> If you want this permanent, you will need to go into ROMMON and
> change the baud rate with the confreg command and then reset/power off.
> Someone probably had to do an xmodem transfer at one point and did not
> change the baud rate back to default of 9600.
>
> -Rob
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> ron wilkerson
> Sent: Tuesday, January 12, 2010 7:16 AM
> To: Gaurav Thukral
> Cc: Group study
> Subject: Re: 3560 Switch console access
>
> config register???
>
> On Tue, Jan 12, 2010 at 10:06 AM, Gaurav Thukral
> <pearlgaurav_at_gmail.com>wrote:
>
> > Hi Guys,
> >
> > I am facing one funny problem that whenever i connect my 3560 switch
> > through
> > Console. It Connect at 115200.
> >
> > After Configuring
> >
> > line console 0
> > speed 9600
> >
> > wr
> > reload
> >
> > It again connect at 115200.
> >
> > Regards,
> > Gaurav.
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> >
> _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
> >
> >
> >
> >
> >
> >
> >
>
>
> --
> stop talking
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
Received on Tue Jan 12 2010 - 11:23:43 ART
This archive was generated by hypermail 2.2.0 : Thu Feb 04 2010 - 20:28:41 ART