Re: remove privilege

Try putting 'default' instead of 'no', although it just removes the command on a router that I just tested.

-- 
Regards,
Rick Mur
CCIE2 #21946 (R&S / Service Provider)
Sr. Support Engineer  IPexpert, Inc.
URL: http://www.IPexpert.com
On 22 dec 2009, at 18:54, Jack wrote:
> I use "no" in front of the following command under global configuration mode on a 3500XL switch:
>   privilege exec level 0 show mac-address-table dynamic
> 
> without any error message, but "show runnning-config" shows the command line is still there.
> 
> Any idea how to remove it?
> 
> Below is partial of my configuration:
> privilege interface level 7 sw ac vl
> privilege configure level 7 int
> privilege exec level 0 show mac-address-table dynamic
> privilege exec level 1 sh mac-
> privilege exec level 7 conf t
> privilege exec level 7 sh run br
> 
> 
> Thanks,
> Jack
> 
> 
> Blogs and organic groups at http://www.ccie.net
> 
> _______________________________________________________________________
> Subscription information may be found at: http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net