remove privilege

I use "no" in front of the following command under global configuration
mode on a 3500XL switch:
    privilege exec level 0 show mac-address-table dynamic

without any error message, but "show runnning-config" shows the command
line is still there.

Any idea how to remove it?

Below is partial of my configuration:
privilege interface level 7 sw ac vl
privilege configure level 7 int
privilege exec level 0 show mac-address-table dynamic
privilege exec level 1 sh mac-
privilege exec level 7 conf t
privilege exec level 7 sh run br

Thanks,
Jack

Blogs and organic groups at http://www.ccie.net
Received on Tue Dec 22 2009 - 12:54:39 ART