RE: ASR 1002 Problem

I have a couple of ASR1k's running in my lab, got no issue's with
pinging loopback interfaces

Do a debug "debug ip icmp" and attempt ping.

Also check route to the loopback interface, should be connected but
worth taking a check.

Also which version are you running? I think we have a RL5 & RL6 on the
two I have.

If you want me to take a deeper look unicast your config to me.

/Aminder

---- Snippet ----
CORE_1_ASR1002#show ip int b | in oopba
Loopback0 172.16.10.1 YES NVRAM up
up
CORE_1_ASR1002#ping 172.16.10.1

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.10.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
CORE_1_ASR1002#

Current configuration : 65 bytes
!
interface Loopback0
 ip address 172.16.10.1 255.255.255.0
end
-----------------

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
ron wilkerson
Sent: Friday, December 04, 2009 6:02 PM
To: Yatin Dave
Cc: ccielab_at_groupstudy.com
Subject: Re: ASR 1002 Problem

we're using 1002's and we have no issues pinging local loopbacks..

are you using vrf-lite by chance?

On Fri, Dec 4, 2009 at 12:40 PM, Yatin Dave <dave.yatin_at_gmail.com>
wrote:

> Dear all,
>
> I know this is not the forum to post the matter but I would like to
know
> about you genius that why i am not able to ping the loopback
interfaces
> configured in cisco asr 1002 routers with in the router itself.
>
> I have some problem in the SPA OEM module so I just tried to
configure
> loopbacks 0 and 1 with different IP subnets and try to ping it but I
can't
> get success
>
> May anybody clarify why cisco has changed its IOS XE deviating with
> standard
> IOS in normal router?
>
> Thanks in advance
>
>
> Blogs and organic groups at http://www.ccie.net
>
>
Received on Mon Dec 07 2009 - 12:49:12 ART