Re: BGP dampening parameters

Give it a few minutes and try the command again : ) Sometimes it takes a
bit of time to apply

On Wed, Sep 23, 2009 at 12:18 AM, Anantha Subramanian Natarajan <
anantha.natarajan_at_gravitant.com> wrote:

> Hi All,
>
> Whenever I set the bgp dampening parameters under the bgp process, I could
> see the parameters set by issuing the "show ip bgp dampening parameters"
> command , but when I set the bgp dampening parameters based on a
> route-map,I
> get this message "% dampening reconfiguration in progress for IPv4 Unicast"
> when issued the "show ip bgp dampening parameters".Is that a expected o/p
> .Kindly let me know your inputs.
>
> Thanks for the assistance
>
> Regards
> Anantha Subtramanian Natarajan
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Regards,
Joe Astorino - CCIE #24347 R&S
Technical Instructor - IPexpert, Inc.
Cell: +1.586.212.6107
Fax: +1.810.454.0130
Mailto:  jastorino_at_ipexpert.com
Blogs and organic groups at http://www.ccie.net