srr-bandwidth limit

Hi Guys,

I have a hard 10Mbps Full switchport and I srr-bandwidth limit to 10%, so
effectively the output is 1Mbps? But my verification reflects a bandwidth of
11.12.

Switch#sh int gi1/0/1

GigabitEthernet1/0/1 is up, line protocol is up (connected)

  Hardware is Gigabit Ethernet, address is 0025.b4e2.6c01 (bia
0025.b4e2.6c01)

  MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive set (10 sec)

  Full-duplex, 10Mb/s, media type is 10/100/1000BaseTX

Switch#sh mls qos interface gi1/0/1 queueing

GigabitEthernet1/0/1

Egress Priority Queue : disabled

Shaped queue weights (absolute) : 25 0 0 0 Shared queue weights : 25 25
25 25 The port bandwidth limit : 10 (Operational Bandwidth:11.12)

The port is mapped to qset : 1

Kelvin

Blogs and organic groups at http://www.ccie.net
Received on Wed Sep 02 2009 - 18:42:49 ART