Re: Dot1x Auth-Fail-Vlan is not supported on multi-host mode

What version of IOS?

I recall configuring this using multi-host without getting errors?

On Sun, Aug 23, 2009 at 3:56 PM, CCIE League <ccieleague_at_ymail.com> wrote:

> I am getting the following message when setting Auth fail VLAN where i have
> to config multi-host support also.
>
>
>
> SW1(config-if)#dot1x auth-fail vlan 99
>
> Command rejected: Port is in multi-host mode
>
> Dot1x Auth-Fail-Vlan is not supported on multi-host mode
>
>
> --------Config --------------
> aaa new-model
> aaa authentication dot1x default group radius
>
> dot1x system-auth-control
> dot1x guest-vlan supplicant
> !
> interface FastEthernet0/14
> switchport mode access
> dot1x port-control auto
> dot1x host-mode multi-host
> dot1x guest-vlan 99
> spanning-tree portfast
>
> ------------------------------------------------
>
>
>
>
> Thanks for your help...
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun Aug 23 2009 - 18:26:36 ART