Re: filtering in eigrp

can you please show me some doc-cd reference about you mentioned here below?
i've found myself stuck in a task where it was allowed to modify only delay
but not at the interface level,
i tried with the route-map statement "set metric bw dl rel load mtu" but
i've experienced not exaclty what you said,
only modifying BW seems to be allowed at first, at the end, i've raised up
delay like this:

router eigrp 1
 network 0.0.0.0
 distribute-list route-map SET_DELAY out f0/0
 no auto-summary

route-map SET_DELAY permit 10
 match ip address prefix-list ROUTE_A
 set metric 1544 400000 255 1 1500
!
route-map SET_DELAY permit 20

so my ROUTE_A had a very high metric that upstream routers did not put it
into their routing tables,
but it is still a behavior i don't fully understand.

/R

2009/8/22 R.B. Kumar <seekumarin_at_gmail.com>

> Hi,
>
> I Like to add the points I noticed
>
> *route-map & set metric used along with distribution-list *
> I am able to manipulate only bandwidth parameter, But changing delay
> parameter is of no use
>
> *offset-list*
> By setting the offset value, delay parameter is changed accordingly.
>
> regards,
>
> RBK
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

--
Faeddare pagu, sabidorla meda.
Blogs and organic groups at http://www.ccie.net