Hi, Just want to clear some concept issue here.. once i put "ip rsvp
bandwidth" command under the interface, i should start to see some thing on
rsvp debug? If two direct connected router both have "ip rsvp band"
configured under their interface then i should see then as "rsvp neighbor
using "show ip rsvp neighbor" command?
I am still quite stuck at the RSVP problem now.. seems that opaque LSA
is sending, with the "mpls trafic-eng router-id loopback0" and "mpls
traffic-eng area 0" under OSPF..
"mpls traffic-eng tunnel" and been configured on all routers globally and
interface.. i dun think "mpls ip" is relevant to this issue since the TE
label should be exchanged by RSVP, nevertheless, it is configured on all the
router globally and interface.. but still.. i don't see any RSVP message on
any of the routers.. can someone give me a clue? Thanks!
Best Regards,
Ricky
Blogs and organic groups at http://www.ccie.net
Received on Fri May 15 2009 - 16:45:59 ART
This archive was generated by hypermail 2.2.0 : Mon Jun 01 2009 - 07:04:43 ART