CE to CE routing issue

Hi All,

Sorry for the long post.

please need some assistance with this routing issue.

here is my setup

BB1 ----(OSPF)---- R6 ---(ISIS)--- R2 ---(OSPF)-vrf XYZ--- R3

I have a route being advertised from BB1 12.12.12.12/32 via OSPF to R6 then
redistributed into ISIS. I see the route on router R2 routing table. and i
can ping BB1 12.12.12.12 but i cannot ping from R3 sitting in VRF Site XYZ.
what am i missing.

R2#ping 12.12.12.12

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.12.12.12, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 12/16/28 ms
R2#

BB1:
router ospf 100
 router-id 12.12.12.12
 log-adjacency-changes
 network 12.12.12.12 0.0.0.0 area 0
 network 192.5.10.254 0.0.0.0 area 0

R6:
router ospf 100
 router-id 10.10.6.6
 log-adjacency-changes
 redistribute connected subnets
 redistribute static subnets
 redistribute isis level-1-2 subnets
 network 192.5.10.6 0.0.0.0 area 0

router isis
 net 49.0010.0000.0000.0006.00
 metric-style wide
 mpls traffic-eng router-id Loopback0
 mpls traffic-eng level-2
 redistribute ospf 100 level-1-2
 redistribute bgp 267 route-map LABEL level-1-2
 redistribute isis ip level-2 into level-1 distribute-list 100

R2:
router isis
 net 49.0010.0000.0000.0002.00
 metric-style wide
 redistribute bgp 267 route-map LABEL level-1-2
 redistribute isis ip level-2 into level-1 distribute-list 100

router ospf 100 vrf XYZ
 router-id 172.10.23.2
 log-adjacency-changes
 redistribute bgp 267 metric 200 subnets
 network 172.10.23.0 0.0.0.255 area 0

 address-family ipv4 vrf XYZ
  redistribute ospf 100 vrf XYZ match internal external 1 external 2
  no synchronization
  exit-address-family.

Thanks

Splinter

Blogs and organic groups at http://www.ccie.net
Received on Tue May 12 2009 - 14:24:40 ART