Re: FREEK

Hello and good evening. I hope all is well.

A few options related to this technology, here is a good link which
discusses these (watch the ugly word wrap):

http://www.cisco.com/en/US/docs/ios/wan/configuration/guide/wan_cfg_frm_rly_ps6350_TSD_Products_Configuration_Guide_Chapter.html#wp1001904

FREEK has to be configured on both ends. A little 'digging' from this link:

*
**You must configure both ends of a VC to send keepalives. If one end is
configured as bidirectional, the other end must also be configured as
bidirectional. If one end is configured as request, the other end must be
configured as reply or passive-reply. If one end is configured as reply or
passive-reply, the other end must be configured as request *

HTH,

Andrew Lee Lissitz

2009/4/18 nowy1981 <freemaxis_at_gmail.com>

> If I configured following options on the REQUEST side
>
> map-class frame-relay FREEK
> frame-relay end-to-end keepalive mode request
> frame-relay end-to-end keepalive timer send 5
> frame-relay end-to-end keepalive event-window send 10
> frame-relay end-to-end keepalive error-threshold send 8
>
> do I have to reflect it on the REPLY router?
>
> map-class frame-relay FREEK
> frame-relay end-to-end keepalive mode reply
> frame-relay end-to-end keepalive timer recv 5
> frame-relay end-to-end keepalive event-window recv 10
> frame-relay end-to-end keepalive error-threshold recv 8
>
>
> I mean question that specify only that router should poll every 5 sec with
> event window of 10 and an error threshold of 8, no details about reply side.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Andrew Lee Lissitz
all.from.nj_at_gmail.com
Blogs and organic groups at http://www.ccie.net