Re: Doubt regarding OSPF

This is your final setup.

R1 (P2M Non Br) <---> R2 (Default is Non Br)

OSPF will exchange routes only with these combinations.

Br <-> Br
Br <-> Non Br.
Non Br -> Non Br.

P2P <-> P2P
P2P <-> P2M
P2M <-> P2M

P2M <-> P2M Non Br
P2M Non Br <-> P2M Non Br

So your above combination wont work. Eventhough you may see adjacency
established, the routes wont be in the routing table.

Regards
Thameem

Raghav Bhargava <raghavbhargava12_at_gmail.com>
Sent by: nobody_at_groupstudy.com
06/04/2009 01:41 AM
Please respond to
Raghav Bhargava <raghavbhargava12_at_gmail.com>

To
Cisco certification <ccielab_at_groupstudy.com>
cc

Subject
Doubt regarding OSPF

HI Experts,
Following is my Topology in OSPF with FR:-

R1( hub) <-------> R2 (spoke)

Now R1( point-to-point) and R2 (NBMA)

Therefore I changed the network type on R1 to point-to-multipoint non
broadcast and also used the neighbor command to R2.My neighborship comes
up
on both the sides but I don't see the routes in the Routing Table.??

Is is a normal behaviour of the protocol with the network ( NBMA ) or is
there something that I need to study about??

Please advise.

-- 
Warm Regards
Raghav
Blogs and organic groups at http://www.ccie.net