From: Nitin Venugopal (nitinsworld@gmail.com)
Date: Wed Mar 18 2009 - 19:22:17 ART
Two questions
1. Why ther is Frame -Relay DLCI mapping on the interface mapping
2. Just to test remove frame relay switching command globally and try with '
*frame-relay interface-dlci XXX switched'*
To do this you to shut the interface first.
2. Can you try the same topology ; Between FR and Ethernet with Pseudowire
exmaple
pseudowire ETH-FRAME
encapsulation MPLS
interworking ip
connect FR Serial2/0 405 l2transport
xconnect 2.2.2.2 3 pseudowire ETH-FRAME
Regds
Nitin
On Wed, Mar 18, 2009 at 6:37 PM, backbone systems <
backbone.systems@gmail.com> wrote:
> Scenario,
>
> --------------Ethernet(f0/0)---------
> --------Ethernet(f0/0)------
> CE1------ ----------FR(2/0)-------------
> PE1-------------------P---------------------PE2-----------------
> --FR(2/0)- ---------CE2
> -------------Serial(2/1)----------
> -------------Serial(2/1)-----------
>
> ok....
>
> Now i am doing like to like ATOM....
>
> FR-FR
> ETH-ETH
> HDLC-HDLC
>
> the ethernet and hdlc works fine .....with the configuration but FR-FR
> ATOM is not working..... below is the confing for PE routers i
> applied....i think rest of the routers config is not that imp to
> mention here.....
>
> PE1
>
>
> ip cef
>
>
> frame-relay switching
> mpls label protocol ldp
>
> interface Loopback0
> ip address 2.2.2.2 255.255.255.255
> !
> interface FastEthernet0/0
> no ip address
> duplex half
> xconnect 4.4.4.4 10 encapsulation mpls
> !
> interface FastEthernet0/0.1
> !
> interface Serial2/0
> no ip address
> encapsulation frame-relay
> serial restart-delay 0
> no frame-relay inverse-arp
> frame-relay intf-type dce
> !
> interface Serial2/1
> no ip address
> serial restart-delay 0
> xconnect 4.4.4.4 1 encapsulation mpls
> !
> interface Serial2/2
> ip address 10.0.0.2 255.0.0.0
> mpls ip
> serial restart-delay 0
> !
>
> router ospf 1
> log-adjacency-changes
> network 2.2.2.2 0.0.0.0 area 0
> network 10.0.0.2 0.0.0.0 area 0
> !
> router bgp 1
> no bgp default ipv4-unicast
> bgp log-neighbor-changes
> neighbor 4.4.4.4 remote-as 1
> neighbor 4.4.4.4 update-source Loopback0
> !
> address-family vpnv4
> neighbor 4.4.4.4 activate
> neighbor 4.4.4.4 send-community extended
> exit-address-family
>
> connect FR Serial2/0 201 l2transport
> xconnect 4.4.4.4 3 encapsulation mpls
>
>
> PE2
>
> ip cef
>
> frame-relay switching
> mpls label protocol ldp
>
>
> interface Loopback0
> ip address 4.4.4.4 255.255.255.255
> !
> interface FastEthernet0/0
> no ip address
> duplex half
> xconnect 2.2.2.2 10 encapsulation mpls
> !
> interface Serial2/0
> no ip address
> encapsulation frame-relay
> serial restart-delay 0
> no frame-relay inverse-arp
> frame-relay intf-type dce
> !
> interface Serial2/1
> ip address 11.0.0.4 255.0.0.0
> mpls ip
> serial restart-delay 0
> !
>
> !
> router ospf 1
> log-adjacency-changes
> network 4.4.4.4 0.0.0.0 area 0
> network 11.0.0.4 0.0.0.0 area 0
> !
> router bgp 1
> no bgp default ipv4-unicast
> bgp log-neighbor-changes
> neighbor 2.2.2.2 remote-as 1
> neighbor 2.2.2.2 update-source Loopback0
> !
> address-family vpnv4
> neighbor 2.2.2.2 activate
> neighbor 2.2.2.2 send-community extended
> exit-address-family
>
> !
> !
> !
> logging alarm informational
> connect FR Serial2/0 405 l2transport
> xconnect 2.2.2.2 3 encapsulation mpls
>
>
> -----------------------------------------------------------------------------------------------------------
> ON PE1
>
> R2#SH MPLS L2transport VC
>
> Local intf Local circuit Dest address VC ID Status
> ------------- -------------------------- --------------- ----------
> ----------
> Se2/1 HDLC 4.4.4.4 1 UP
> Se2/0 FR DLCI 201 4.4.4.4 3 DOWN
> Fa0/0 Ethernet 4.4.4.4 10 UP
> R2#
>
>
> R2#SH MPLS L2transport BInding
> Destination Address: 4.4.4.4, VC ID: 1
> Local Label: 21
> Cbit: 1, VC Type: HDLC, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
> Remote Label: 19
> Cbit: 1, VC Type: HDLC, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
> Destination Address: 4.4.4.4, VC ID: 3
> Local Label: unassigned.
> Remote Label: unassigned
> Destination Address: 4.4.4.4, VC ID: 10
> Local Label: 19
> Cbit: 1, VC Type: Ethernet, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
> Remote Label: 20
> Cbit: 1, VC Type: Ethernet, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
>
>
> -----------------------------------------------------------------------------------------------------------------------------------------------------------------------
>
> PE2
>
>
> R4#SH MPLS L2transport VC
>
> Local intf Local circuit Dest address VC ID Status
> ------------- -------------------------- --------------- ----------
> ----------
> Se2/2 HDLC 2.2.2.2 1 UP
> Se2/0 FR DLCI 405 2.2.2.2 3 DOWN
> Fa0/0 Ethernet 2.2.2.2 10 UP
>
>
> R4#SH MPLS L2transport BInding
> Destination Address: 2.2.2.2, VC ID: 1
> Local Label: 19
> Cbit: 1, VC Type: HDLC, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
> Remote Label: 21
> Cbit: 1, VC Type: HDLC, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
> Destination Address: 2.2.2.2, VC ID: 3
> Local Label: unassigned.
> Remote Label: unassigned
> Destination Address: 2.2.2.2, VC ID: 10
> Local Label: 20
> Cbit: 1, VC Type: Ethernet, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
> Remote Label: 19
> Cbit: 1, VC Type: Ethernet, GroupID: 0
> MTU: 1500, Interface Desc: n/a
> VCCV: CC Type: CW [1], RA [2]
> CV Type: LSPV [2]
>
>
>
> As u can see from the above command that no local and remote binding
> is assigned for VC=3 which is FR.......
>
> Can any one tell me what is the problem????
>
> appreciate ur help.....
>
> BB
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:05 ART