From: Akber Ali Mirza (akberali.cisco@gmail.com)
Date: Fri Mar 06 2009 - 09:55:48 ARST
Hello GS,
Appreciate your response on the below mail!
Regards,
Akber Mirza.
On Fri, Mar 6, 2009 at 1:39 PM, Akber Ali Mirza <akberali.cisco@gmail.com>wrote:
> Hi GS,
>
> I want to setup SMARTS tool in my network to monitor the Internet link and
> other links as well.
>
> As my links are terminated on ehternet ports from service provider unlike
> they terminate on Router's serial interface.
>
> I wanted to know which ip address of my Internet router interface should i
> advertise in the SMARTS tool to get the alert in my Tool
>
> Please look at the following data-
>
> Router Internet is terminated on a Ethernet port Fa0/3 & Fa0/4 and
> configured with a BGP protocol.
>
> Loop backaddress is also configured for these above two interface for
> sending the BGP protocol information via these Loopbacks.
> neighbor X.X.X.X update-source Loopback1 - ISP A
> neighbor X.X.X.X update-source Loopback2 - ISP B
>
> As Internet link termination happening over here on a Ethernet port which
> will not go down even though the Link is down .
>
> Looking for a solution how SMARTS will recognise and show alarms in these
> circumstances.
>
> Also does it recognise Protocols ( BGP/OSPF) down /up stauts.
>
> I request you to please unicast me your suggestion .
>
> Thanks in advance!
>
>
> Regards,
> Akber Mirza.
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Apr 06 2009 - 06:44:04 ART