From: GAURAV MADAN (gauravmadan1177@gmail.com)
Date: Sun Feb 08 2009 - 15:31:48 ARST
Well ur config looks to be in shape .
thing I can say to you abt etherchannel problems is ..... the sequence of
aplying commands matter a lot .
So go ahead .. unconfigue .... configre again .. by configuring the ends
where u are enabling "channel-group mode<>" cli and then doing at other end
.
This will work .. i generealy do this when i face such problems
Gaurav Madan
On Sun, Feb 8, 2009 at 8:00 PM, NET HE <he_net@hotmail.com> wrote:
> In 3560 configuration guide, it says
>
> "with layer 3 ports, you should manually create the logical interface by
> using
> the interface port-channel glocal configuration command followed by the no
> switchport interface configuration command. Then you manually assign an
> interface to the EtherChannel by using the channel-group interface
> configuration command. "Best Regards, Net (Xin) He > Date: Sun, 8 Feb 2009
> 17:10:09 +0300> Subject: Re: PROBLEM WITH ETHERCHANNEL> From:
> karim.jamali@gmail.com> To: ccielab@groupstudy.com> > It is not needed
> since
> iuthe no switchport command is already assigned on the> member
> interfaces.> The
> portchannel is layer 3.> > On Sun, Feb 8, 2009 at 5:02 PM, NET HE
> <he_net@hotmail.com> wrote:> > > Do you have cmd "no switchport" under the
> "int port34" ?> >> > Best Regards,> > Net (Xin) He> >> >> >> >> > > Date:
> Sun,
> 8 Feb 2009 10:07:19 +0300> > > Subject: PROBLEM WITH ETHERCHANNEL> > >
> From:
> karim.jamali@gmail.com> > > To: ccielab@groupstudy.com> >> > >> > > Dear
> Experts,> > >> > > Scenario 4 switches: SW1,SW2,SW3, & SW4. Layer 3
> Etherchannel is to be> > > formed between SW4 (16&18) and SW3(13-14).> > >>
> >
> > SW4(16-18) CONNECTED TO SW2 (FA0/19,FA0/21)> > > SW3(13-14) CONNECTED TO
> SW1
> (FA0/16,FA0/17)> > >> > > Dot1q tunneling has been configured between the
> two
> switches (SW2 AND> > SW1).> > > Configuration is as follows:> > >> > > SW4>
> >
> > conf t> > > int range fa0/16,fa0/18> > > no switchport> > > sh> > >
> channel-group 34 mode desirable> > >> > > int port34> > > ip add
> 156.18.109.10
> 255.255.255.0> > > int range fa0/16,fa0/18> > > no sh> > >> > > SW3> > >
> conf
> t> > >> > > int range fa0/13-14> > > no switchport> > > sh> > >
> channel-group
> 34 mode desirable> > >> > > int port34> > > ip add 156.18.109.9
> 255.255.255.0>
> > >> > > int range fa0/13-14> > > no sh> > >> > > SW1> > > conf t> > > int
> fa0/16> > > switchport mode dot1q-tunnel> > > l2protocol-tunnel
> point-to-point
> pagp> > > switchport access vlan 100> > > no sh> > >> > > int fa0/17> > >
> switchport mode dot1q-tunnel> > > l2protocol-tunnel point-to-point pagp> >
> >
> switchport access vlan 200> > > no sh> > >> > > SW2> > > conf t> > > int
> fa0/19> > > switchport mode dot1q-tunnel> > > l2protocol-tunnel
> point-to-point
> pagp> > > switchport access vlan 100> > > no sh> > >> > > int fa0/21> > >
> switchport mode dot1q-tunnel> > > l2protocol-tunnel point-to-point pagp> >
> >
> switchport access vlan 200> > > no sh> > >> > >> > > I am getting the error
> message: CANNOT BUNDLE ETHERCHANNEL NOT ENABLED ON> > > THE REMOTE DEVICE.>
> >
> >> > > I have no clue what could be causing this.> > >> > > --> > > KJ> >
> >> >
> >> > > Blogs and organic groups at http://www.ccie.net> > >> > >
> _______________________________________________________________________> >
> >
> Subscription information may be found at:> > >
> http://www.groupstudy.com/list/CCIELab.html> > >> > >> > >> > >> > >> > >>
> >
> >> >> > ------------------------------> > So many new options, so little
> time.
> Windows Live
> Messenger.<http://www.microsoft.com/windows/windowslive/messenger.aspx>>
> >> >
> > > -- > KJ> > > Blogs and organic groups at http://www.ccie.net> >
> _______________________________________________________________________>
> Subscription information may be found at: >
> http://www.groupstudy.com/list/CCIELab.html> > > > > > >
> _________________________________________________________________
> Windows Live Messenger. Multitasking at its finest.
> http://www.microsoft.com/windows/windowslive/messenger.aspx
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sun Mar 01 2009 - 09:44:10 ARST