From: NET HE (he_net@hotmail.com)
Date: Sun Feb 08 2009 - 12:02:37 ARST
Do you have cmd "no switchport" under the "int port34" ?Best Regards, Net
(Xin) He > Date: Sun, 8 Feb 2009 10:07:19 +0300> Subject: PROBLEM WITH
ETHERCHANNEL> From: karim.jamali@gmail.com> To: ccielab@groupstudy.com> > Dear
Experts,> > Scenario 4 switches: SW1,SW2,SW3, & SW4. Layer 3 Etherchannel is
to be> formed between SW4 (16&18) and SW3(13-14).> > SW4(16-18) CONNECTED TO
SW2 (FA0/19,FA0/21)> SW3(13-14) CONNECTED TO SW1 (FA0/16,FA0/17)> > Dot1q
tunneling has been configured between the two switches (SW2 AND SW1).>
Configuration is as follows:> > SW4> conf t> int range fa0/16,fa0/18> no
switchport> sh> channel-group 34 mode desirable> > int port34> ip add
156.18.109.10 255.255.255.0> int range fa0/16,fa0/18> no sh> > SW3> conf t> >
int range fa0/13-14> no switchport> sh> channel-group 34 mode desirable> > int
port34> ip add 156.18.109.9 255.255.255.0> > int range fa0/13-14> no sh> >
SW1> conf t> int fa0/16> switchport mode dot1q-tunnel> l2protocol-tunnel
point-to-point pagp> switchport access vlan 100> no sh> > int fa0/17>
switchport mode dot1q-tunnel> l2protocol-tunnel point-to-point pagp>
switchport access vlan 200> no sh> > SW2> conf t> int fa0/19> switchport mode
dot1q-tunnel> l2protocol-tunnel point-to-point pagp> switchport access vlan
100> no sh> > int fa0/21> switchport mode dot1q-tunnel> l2protocol-tunnel
point-to-point pagp> switchport access vlan 200> no sh> > > I am getting the
error message: CANNOT BUNDLE ETHERCHANNEL NOT ENABLED ON> THE REMOTE DEVICE.>
> I have no clue what could be causing this.> > -- > KJ> > > Blogs and organic
groups at http://www.ccie.net> >
This archive was generated by hypermail 2.1.4 : Sun Mar 01 2009 - 09:44:10 ARST