From: Peter Chuba (ptchuba@live.com)
Date: Mon Dec 29 2008 - 02:45:12 ARST
Thanks Gaurav.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
GAURAV MADAN
Sent: Monday, December 29, 2008 5:35 AM
To: Peter Chuba
Cc: ccielab@groupstudy.com
Subject: Re: can't enter switchport protected command
This is expected
NM-16ESW donot support protected fport eature.
Gaurav Madan
On Mon, Dec 29, 2008 at 9:36 AM, Peter Chuba <ptchuba@live.com> wrote:
> Hi,
>
> Am I supposed to be able to use the "switchport protected" command with
> NM-16ESW? I'm using dynamips and for some reason this command is not
> available. Searched the web but couldn't come up with anything.
>
>
>
> Router#sh ver
>
> *Mar 1 01:26:30.915: %SYS-5-CONFIG_I: Configured from console by console
>
> Cisco IOS Software, 3600 Software (C3640-JK9O3S-M), Version 12.3(14)T7,
> RELEASE SOFTWARE (fc2)
>
> Technical Support: http://www.cisco.com/techsupport
>
> Copyright (c) 1986-2006 by Cisco Systems, Inc.
>
> Compiled Wed 22-Mar-06 21:46 by pwade
>
>
>
> ROM: ROMMON Emulation Microcode
>
> ROM: 3600 Software (C3640-JK9O3S-M), Version 12.3(14)T7, RELEASE SOFTWARE
> (fc2)
>
>
>
>
>
> Router(config)#int f0/2
>
> Router(config-if)#switchport ?
>
> access Set access mode characteristics of the interface
>
> mode Set trunking mode of the interface
>
> trunk Set trunking characteristics of the interface
>
> <cr>
>
> priority Set 802.1p priorities
>
> voice Voice appliance attributes
>
>
>
> Router(config-if)#switchport protected
>
> ^
>
> % Invalid input detected at '^' marker.
>
>
>
> Router(config-if)#
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:10 ARST