From: Peter Chuba (ptchuba@live.com)
Date: Mon Dec 29 2008 - 02:06:19 ARST
Hi,
Am I supposed to be able to use the "switchport protected" command with
NM-16ESW? I'm using dynamips and for some reason this command is not
available. Searched the web but couldn't come up with anything.
Router#sh ver
*Mar 1 01:26:30.915: %SYS-5-CONFIG_I: Configured from console by console
Cisco IOS Software, 3600 Software (C3640-JK9O3S-M), Version 12.3(14)T7,
RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 22-Mar-06 21:46 by pwade
ROM: ROMMON Emulation Microcode
ROM: 3600 Software (C3640-JK9O3S-M), Version 12.3(14)T7, RELEASE SOFTWARE
(fc2)
Router(config)#int f0/2
Router(config-if)#switchport ?
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
trunk Set trunking characteristics of the interface
<cr>
priority Set 802.1p priorities
voice Voice appliance attributes
Router(config-if)#switchport protected
^
% Invalid input detected at '^' marker.
Router(config-if)#
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:10 ARST