From: Xiaobo Zhu (xiaobo@zhu.net)
Date: Fri Dec 26 2008 - 05:38:48 ARST
Hi,
thanks for you reply.
Sorry but there are no extra information about bandwidth or delay.
Anyway, the explanation from Testking is R4 will choose to install the route
with the lowest administrative distance into the routing table. so they
believe the way through R3 is more preferred.
What I am confusing about is that is there any mechanism on tagging the
source routing protocol of the external routes? I used to think that in the
R4's view, the route of 1.1.1.0/24 comes from both R2 and R3 is 170. The
explanation doesn't seem to make sense.
Further suggestions are welcomed.
Regards.
Xiaobo
On Fri, Dec 26, 2008 at 3:17 PM, Timothy Chin <Tim@1c-solutions.com> wrote:
> This would depend on R4's connection speed to Routers R3 and R4 because
> of the delay factor.
>
> Tim
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> Xiaobo Zhu
> Sent: Friday, December 26, 2008 2:05 AM
> To: Cisco certification
> Subject: Redistribute issue
>
> Hi,
> take this scenario
> R1---RIP-----R2
> | |
> OSPF EiGRP 1
> | |
> R3---EIGRP 1--R4
>
> R1 has an loopback 0 with ip address 1.1.1.0/24, which is advertise to
> R2
> via RIP and advertised to R3 via OSPF.
> As the digram shows, R2, R3 and R4 are in the same EIGRP domain.
> The question is if R2 redistribute and R3 both redistribute 1.1.1.0 to
> R4
> with the same K value, which path will R4 take to reach the
> 1.1.1.0/24network.
> Many thanks!
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:10 ARST