From: Pavel Bykov (slidersv@gmail.com)
Date: Wed Dec 17 2008 - 00:27:06 ARST
Agree with Dale.
I have seen this mishap with config ragister a lot, when it is set to
something like 0x1
Set it to standard autoboot and you should be good to go
On Wed, Dec 17, 2008 at 3:16 AM, Dale Shaw <dale.shaw@gmail.com> wrote:
> Hi Jeffrey,
>
> On Wed, Dec 17, 2008 at 11:58 AM, Jeffrey Biggs <j.biggs@myactv.net>
> wrote:
> >
> > Trying to setup SUP720's redundant in a 6509 chassis and need some good
> > documentation to find out why the chassis boots into rommon until I tell
> it
> > to "boot" then the IOS takes off and the RP then boots. I have my
> > "theories" but they are nothing more than that as it is hard to find a
> good
> > link to some documentation on setting this up.
>
> I've seen this happen when the SP has the wrong config-register.
>
> Once the RP is booted, login and run:
>
> "remote command switch show boot"
>
> If it's something other than 0x2102, or some other value that means
> it'll go into ROMMON, just re-enter the config-register in the RP and
> write the config -- the proper value will be propagated to the SP
> (verify with the same command as above).
>
> cheers,
> Dale
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>
-- Pavel Bykov ---------------- Don't forget to help stopping the braindumps, use of which reduces value of your certifications. Sign the petition at http://www.stopbraindumps.com/Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:09 ARST