From: Hobbs (deadheadblues@gmail.com)
Date: Sat Nov 29 2008 - 19:01:36 ARST
Hello,
I am following the DocCD as well as a couple archives but I cannot seem to
get this to work. I have the following topology:
R1---ethernet---R2---frame---R5---ethernet---R7---serial---R8---ethernet
R1 is my manager
R2 is my test sender (LAN interface = 172.31.12.2)
R7 and R8 are my test receivers (LAN interfaces = 172.31.200.7,172.31.80.8)
R5 is an RP
All LAN interfaces have ip igmp join-group 239.1.1.1
Pim sparse-dense everywhere and I can ping the group address from any router
above - not sure if this is a requirement for MRM.
R1's config:
access-list 21 permit 172.31.12.2
access-list 22 permit 172.31.200.7
access-list 22 permit 172.31.80.8
ip mrm manager MyTest
manager FastEthernet0/0 group 239.1.1.1
senders 21
receivers 22 no-join
receivers 22 sender-list 21
R7 and R8 have the test-receiver command on LAN interfaces.
R2 has the test-sender command on LAN interface.
I debug mrm events and packets but this is all I get on R1:
R1#
Nov 29 20:54:50.614: MRM: Send Beacon for group 239.1.1.1, holdtime 83400
seconds
Nov 29 20:55:50.614: MRM: Send Beacon for group 239.1.1.1, holdtime 83340
seconds
Nov 29 20:56:50.614: MRM: Send Beacon for group 239.1.1.1, holdtime 83280
seconds
Is there something I need to do to generate output?
thanks
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:32 ARST