From: Brandon Carroll (brandon.j.carroll@gmail.com)
Date: Sat Nov 29 2008 - 14:38:34 ARST
I have also seen issues with 8.0 3.
Sent from my iPhone
On Nov 29, 2008, at 7:24 AM, Yahoo! <satandaemon@yahoo.com> wrote:
> Smile, I have a "state" link on the same failover link,
> I guess you didn't read question carefully, its working from active
> unit to standby unit smoothly...
>
>
> --- On Sat, 11/29/08, Smile <sk180174@gmail.com> wrote:
>
>> From: Smile <sk180174@gmail.com>
>
>> You should have a interface for the state only then is the
>> ISAKMP and IPSec
>> tables kept.
>>
>
>> <satandaemon@yahoo.com> wrote:
>>
>>> GS,
>
> Failover On
> Failover unit Primary
> Failover LAN Interface: failover GigabitEthernet0/1 (up)
> Unit Poll frequency 1 seconds, holdtime 15 seconds
> Interface Poll frequency 5 seconds, holdtime 25 seconds
> Interface Policy 1
> Monitored Interfaces 4 of 250 maximum
> failover replication http
> Version: Ours 8.0(3)6, Mate 8.0(3)6
> Last Failover at: 12:41:18 UTC Nov 28 2008
> This host: Primary - Active
> Active time: 64098 (sec)
> slot 0: ASA5520 hw/sw rev (2.0/8.0(3)6) status (Up Sys)
> Interface outside : Normal
> Interface wan : Normal
> Interface dmz : Normal
> Interface management : Normal
> slot 1: ASA-SSM-40 hw/sw rev (1.0/6.0(4)E1) status (Up/
> Up)
> IPS, 6.0(4)E1, Up
> Other host: Secondary - Standby Ready
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:32 ARST