From: Yahoo! (satandaemon@yahoo.com)
Date: Sat Nov 29 2008 - 13:24:13 ARST
Smile, I have a "state" link on the same failover link,
I guess you didn't read question carefully, its working from active unit to standby unit smoothly...
--- On Sat, 11/29/08, Smile <sk180174@gmail.com> wrote:
> From: Smile <sk180174@gmail.com>
> You should have a interface for the state only then is the
> ISAKMP and IPSec
> tables kept.
>
> <satandaemon@yahoo.com> wrote:
>
> > GS,
Failover On
Failover unit Primary
Failover LAN Interface: failover GigabitEthernet0/1 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 4 of 250 maximum
failover replication http
Version: Ours 8.0(3)6, Mate 8.0(3)6
Last Failover at: 12:41:18 UTC Nov 28 2008
This host: Primary - Active
Active time: 64098 (sec)
slot 0: ASA5520 hw/sw rev (2.0/8.0(3)6) status (Up Sys)
Interface outside : Normal
Interface wan : Normal
Interface dmz : Normal
Interface management : Normal
slot 1: ASA-SSM-40 hw/sw rev (1.0/6.0(4)E1) status (Up/Up)
IPS, 6.0(4)E1, Up
Other host: Secondary - Standby Ready
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:32 ARST