From: Luan Nguyen (luan@netcraftsmen.net)
Date: Sat Nov 22 2008 - 12:50:07 ARST
That's just the load-interval command right?
Luan Nguyen
Chesapeake NetCraftsmen, LLC.
www.NetCraftsmen.net
(e) luan@netcraftsmen.net
(aim/yahoo/gtalk): luancnc
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Radioactive Frog
Sent: Saturday, November 22, 2008 9:39 AM
To: But Nicky
Cc: Cisco certification
Subject: Re: How to change time for average output throughput on interface.
Good question But.N.
I don't think u can change that. that is coded in the IOS. I would be
intrersting if someone managed to get that down to 2 minutes!
-frog
On Sun, Nov 23, 2008 at 1:30 AM, But Nicky <lyredhair@gmail.com> wrote:
> Hi all,
> I want to change time for average output throughput on interface, default
> parameter is 5 mins
> !
> Rack3R5(config-if)#do sh int se 0/0/1 | in output rate
> * 5 minute* output rate 0 bits/sec, 0 packets/sec
> !
> I want to change into "5 minute" --> "2 minute"
>
> Thanks,
> But Nguyen.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:31 ARST