From: Edouard Zorrilla (ezorrilla@tsf.com.pe)
Date: Sun Nov 09 2008 - 10:17:06 ARST
I am a kind of confusing regarding this, for instance the command : " peer
ip address X.X.X.14 255.255.255.0"
It means I do not need to enter any command on the peer context which is
working as a standby ? If so what do I need to enter on the peer context ?.
Would you please unicast me with the config on both contexts ?
Thanks a lot for your patience,
Regards
----- Original Message -----
From: "amernas" <taloust@gmail.com>
To: "'Edouard Zorrilla'" <ezorrilla@tsf.com.pe>; <ccielab@groupstudy.com>
Cc: <security@groupstudy.com>
Sent: Sunday, November 09, 2008 7:02 AM
Subject: RE: ACE Sample Configs
Here is an example of the configuration of the primay ACE with 2 contexts
RED-1 and BLUE-1
###################################
..
..
hostname ACE-PRIMARY
..
..
resource-class RED
limit-resource all minimum 45.00 maximum equal-to-min
resource-class BLUE
limit-resource all minimum 45.00 maximum equal-to-min
...
...
interface vlan 2
description MANAGEMENT INTERFACE
ip address X.X.X.13 255.255.255.0
peer ip address X.X.X.14 255.255.255.0
service-policy input ACE-MGMT-TRAFFIC
no shutdown
ft interface vlan 52
description FAILOVER AND SYNC INTERFACE
ip address X.X.X.1 255.255.255.0
peer ip address X.X.X.2 255.255.255.0
no shutdown
..
..
context RED-1
description RED-1 CONTEXT
allocate-interface vlan 9
allocate-interface vlan 30-31
allocate-interface vlan 55
member RED
context BLUE-1
description BLUE-1 CONTEXT
allocate-interface vlan 7
allocate-interface vlan 40-41
allocate-interface vlan 50
member BLUE
..
..
ft peer 1
heartbeat interval 1000
heartbeat count 10
ft-interface vlan 52
ft group 1
peer 1
peer priority 90
associate-context ADMIN-CONTEXT
inservice
ft group 2
peer 1
peer priority 90
associate-context RED-1
inservice
ft group 3
peer 1
peer priority 90
associate-context BLUE-1
inservice
############################################
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Edouard Zorrilla
Sent: Saturday, November 08, 2008 11:54 PM
To: ccielab@groupstudy.com
Cc: security@groupstudy.com
Subject: ACE Sample Configs
Anyone who has more real examples how to set up a ACE (Application Control
Engine) module ? I found this :
http://www.cisco.com/en/US/products/ps6906/tsd_products_support_model_home.h
t
ml
But I gues this is not enough since the examples do not show how to set up
the standby module,
Regards
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:30 ARST